HI, The belly bumper cover has to come off as a couple of lower headlamp assembly bolts are located in back it. Here are directions engross recall to rate relieve using the rating page thus that I may receive credit. Thanks
Thanks for your response. I just checked what you mentioned, that I hadn't already checked, except fuel pressure.Let me tell you a little more very nearly the burden history. It currently has a master tech qualified idle let breathe control valve and tps installed. without distressing anything, the last (used) ecu and my original, would direct in the car without this symptom.
This could be a large vacuum leak ,with the MAF aligned it is on your own measuring the ventilate that is getting similar to the MAF, for that reason if the intake manifold is sucking in expose the let breathe to fuel ratio will be extremely out and cause the engine to stall. If MAF is disconnected the engine goes into a limp measurement and lets the engine run. in the same way as carb cleaner spray can vaporizer in the area of the hissing following the engine supervision and in the manner of you listen the engine stall or rev future there is the leak ,could be a bad vacuum hose bad gasket on the manifold.